Articles · Infrastructure & Cities
A door worthy of the water supply
Inspectors keep finding the same open door at water systems: shared logins and passwords never changed. TapCheck gives every person and vendor a key of their own, and receipts every entry.
By Lucian · Lux Automations
The problem
A city’s water network runs on control systems that operators and vendors cross into every day. Too often they cross on a single shared login, or on a default password that was never changed from the day the equipment was installed. When everyone uses the same key, no one can say who was in, and a key that never changes is a key anyone can eventually learn.
The EPA reported that more than 70% of water systems inspected since September 2023 were not fully compliant with their risk-assessment and emergency-response duties — and inspectors specifically found default passwords never changed and single shared logins. A separate EPA review of 1,062 large systems found 97 with critical or high-risk vulnerabilities, serving about 26.6 million people. These are not exotic failures. They are the front door, left as it was found.
Many of the systems carrying this risk are small, with no security staff of their own. The people running the water are doing the work; what they have never been given is a door that makes the safe way the ordinary way.
The technology
TapCheck replaces the shared key with an issued key per person. Every operator and every vendor holds a key of their own, in their own name. Shared logins and default passwords die at this door, because there is nothing shared left to use and nothing default left to guess.
Access is then mandate-checked to the systems their job touches. A key opens only what its holder’s work requires, and no more. The vendor in to service one system holds a mandate for that system, not a general pass to the network. The operator’s key follows the operator’s duties, in the same way.
Every entry is receipted, straight into the risk-assessment file. The record is not a separate chore done from memory at audit time; it is written by the entries themselves. Underneath, it is the house engine: Amos checks who is knocking, SeamGuard checks the joins between systems, and every check leaves a signed receipt. When a staffer leaves or a vendor’s work ends, that key can be revoked in a moment, and it stops working instantly while everyone else’s keys carry on.
What it changes
For a water system, the compliance file begins to write itself from the record. That matters on a real clock: mid-size systems face a recertification deadline of December 31, 2026, and the product page’s promise is that the record is ready before it arrives. An inspector asking who can enter, and who did, gets an answer drawn from receipts rather than recollection.
It changes daily practice, too. Naming every person at the door ends the quiet habit of the shared login, which persists mostly because it is convenient. An issued key of one’s own is just as convenient, and it carries a name. Vendors, likewise, cross under their own keys and their own mandates, which protects the honest vendor as much as it checks the careless one.
No shared logins. No default passwords. That is the whole standard, and it is a door worthy of the water supply: every person known, every entry receipted, every key revocable the moment it should be.
See it
TapCheck checks the systems on a city’s water network, one issued key and one receipt at a time. TapCheck — the product page · All the house articles · Lux Automations — ailux.ca